Nuts, Bolts & Corresponding Socket Sizes
Posted: Tue Jun 21, 2022 1:11 pm
Engine
Valve cover - 10mm
Spark plug cover - 10mm
Crank pulley bolt - 19mm head, 16mm bolt, 181 ft*lbs
Intake Manifold to head flange - 12mm
Exhaust Manifold to head flange -12mm
Water neck - 12mm
Radiator brackets: 10 MM
Ignition coil bracket: 10 MM
Clutch & Tranny:
drain bolt: 3/8" socket fitting
fill bolt: 17mm
master cylinder mounting bracket: 10mm
slave cylinder bolts: 12mm
clutch hardline brackets 10mm & 12mm
flywheel bolts: 17mm 12-point
pressure plate bolts: 10mm 12-point
transmission housing bolts (the ones that hold the two halves of the tranny together): 12mm & 14mm
shifter assembly bolts: 10mm
shift cable bracket bolts: 12mm
tranny mounting bolts (hold the tranny to the block): 17mm
pedal rod adjustment nut: 12mm
engine stiffener: 14mm and 10mm
Chassis/Suspension:
Shock Tower - 14mm
Lower control arm/shock fork - 17mm
Upper fork bolt - 14mm head, 10mm bolt, 32 ft*lbs
Lugs - 19mm
Front Wheel Hub - 36mm (IIRC)
Rear Wheek Hub - 32mm (IIRC)
front and rear lower shock mounts: 17mm
front and rear upper shock mounts: 14mm
front and rear shock shaft nuts: 14mm
front shock fork pinch bolt: 14mm
front inner lower control arm: 17mm
rear inner lower control arm: 19mm
front upper control arm: 14mm
rear upper control arm: 14mm
rear upper control arm mount: 17mm
front and rear upper ball joints: 14mm
front and rear lower ball joints: 19mm (not 100% sure on the rear)
outer tie rod ball joints: 17mm
base radius rods: 17mm (I don't recall the SH bolt sizes)
Brakes:
front caliper bolts: 14mm
front caliper brackets: 17mm
rear caliper bolts: 12mm
rear caliper bracket bolts: 14mm
brake line brackets: 12mm
ABS sensor brackets and mount: 10mm
master cylinder bracket: 12mm
Interior:
Seat Bolts = 14mm
Seat Belt = 14mm
Oh Shit Bar = 10mm (i think, could be 8mm)
Dash Bolts = 10mm (and phillips screws)
Door panel = Phillips screws
Sunroof Panel = 10mm
Door Hinge = 12mm
Valve cover - 10mm
Spark plug cover - 10mm
Crank pulley bolt - 19mm head, 16mm bolt, 181 ft*lbs
Intake Manifold to head flange - 12mm
Exhaust Manifold to head flange -12mm
Water neck - 12mm
Radiator brackets: 10 MM
Ignition coil bracket: 10 MM
Clutch & Tranny:
drain bolt: 3/8" socket fitting
fill bolt: 17mm
master cylinder mounting bracket: 10mm
slave cylinder bolts: 12mm
clutch hardline brackets 10mm & 12mm
flywheel bolts: 17mm 12-point
pressure plate bolts: 10mm 12-point
transmission housing bolts (the ones that hold the two halves of the tranny together): 12mm & 14mm
shifter assembly bolts: 10mm
shift cable bracket bolts: 12mm
tranny mounting bolts (hold the tranny to the block): 17mm
pedal rod adjustment nut: 12mm
engine stiffener: 14mm and 10mm
Chassis/Suspension:
Shock Tower - 14mm
Lower control arm/shock fork - 17mm
Upper fork bolt - 14mm head, 10mm bolt, 32 ft*lbs
Lugs - 19mm
Front Wheel Hub - 36mm (IIRC)
Rear Wheek Hub - 32mm (IIRC)
front and rear lower shock mounts: 17mm
front and rear upper shock mounts: 14mm
front and rear shock shaft nuts: 14mm
front shock fork pinch bolt: 14mm
front inner lower control arm: 17mm
rear inner lower control arm: 19mm
front upper control arm: 14mm
rear upper control arm: 14mm
rear upper control arm mount: 17mm
front and rear upper ball joints: 14mm
front and rear lower ball joints: 19mm (not 100% sure on the rear)
outer tie rod ball joints: 17mm
base radius rods: 17mm (I don't recall the SH bolt sizes)
Brakes:
front caliper bolts: 14mm
front caliper brackets: 17mm
rear caliper bolts: 12mm
rear caliper bracket bolts: 14mm
brake line brackets: 12mm
ABS sensor brackets and mount: 10mm
master cylinder bracket: 12mm
Interior:
Seat Bolts = 14mm
Seat Belt = 14mm
Oh Shit Bar = 10mm (i think, could be 8mm)
Dash Bolts = 10mm (and phillips screws)
Door panel = Phillips screws
Sunroof Panel = 10mm
Door Hinge = 12mm